| |
|
 |
|
 |
|
 |
|
 |
|
 |
|
| |
 |
CK Industrial Engineers Ltd
Unit 4-7 Enterprise Way
Wickford Business Park
Wickford
Essex
SS11 8DH
United Kingdom
Tel: +44 (0)1268 561471
Fax: +44 (0)1268 764891
Email: enquiries@ck-ind.com
Registered in England
Company No.: 1707058
VAT No.: GB 710 2650 82
|
Products
We design and manufacture Fixtures & Tooling for
all stages of the Final Assembly process associated
with Engine, Gearbox & Axles. This process
culminates in a complex operation of 'Marriage'
(also called 'Decking' or 'Stuff-up') of the
PowerTrain system to vehicle bodies.
We also design and manufacture, Door Carriers, Vehicle Body Carriers and other tools used in the automotive industry.
Elevator Door Barrier
|
We design and produce Elevator Door Barriers. The elevator door barrier creates a Protection Zone in front of the elevator doors protecting them from damage from trolleys and other wheeled devices.
Potential damage to the elevator doors, could eventually lead the the elevator malfunctioning and being taken out of service.
| |
 |
|
|
The Protection Zone created by the floor mounted barrier when in the raised position will not allow trolleys or any other wheeled device to get too close and therefore collide with the elevator door or surrounding area.
When raised the barrier presents an impassable obstacle to all oncoming trolleys etc.
As a safety measure however the barrier remains low enough for other foot-traffic to step over and pass where necessary.
| |
 |
|
|
 |
|
The barrier developed is principally a simple floor-mounted horizontal hinge type of device with a central pin secured between a pair of motorised lifting towers.
When the barrier is activated the central pin is raised and the attached pivoting door-plates create a solid barrier, impassable to all oncoming luggage trolleys etc.
| |
When in the lowered position the barrier will lay flat against the floor / base plate, presenting only a slight hump that any trolleys will have to be pushed over to pass by.
The barrier can be mechanically locked down independently of its electricity supply being connected or disconnected, useful in case of power failure or for maintenance
The control environment has been specifically developed such that the barrier can be retro-fitted to any elevator using a surface mounted exterior door sensor to pilot the operation and requiring only a 240V AC 10 amp single phase power supply thus ensuring quick and easy incorporation in any existing or new situation.
|
|
Copyright © 2009 - 2010 CK Industrial Engineers Ltd
Design and manufacture of jigs and fixtures, automotive tooling, UK
